Transofine Finish 4.04

Physical properties

Color / Gloss by color card / Highlight

Volume solids approx . 40%

Flash point

Volatile organic components ( VOC ) about 75 gram / L 

Density Approx. 1.2 g / centimeter ³

Construction instructions

Guidelines for airless spraying 

Nozzle pressure : 12-15 MPa  

Nozzle aperture : 0.38-0.48 mm 

Spraying angle : 60-80 Spend

Dilution ratio: diluent is not recommended

Guidelines for  air spraying 

Nozzle pressure : 0.2-0.3 MPa

Dilution ratio: 0-5% (volume ratio)

Nozzle aperture: 1.2-1.5 mm

brush or roller application  , dilution ratio: 0-5% (volume ratio )

Thinner / cleaner  pure water

Avoid adding excessive thinner, otherwise it will reduce its anti-sagging and gloss of the coating.

Drying time and time between recoating ⁽¹⁾

(1)After painting 48 Avoid contact with water vapor within 7 hours. Avoid washing with water for 1 day.

The data is for reference only. The actual drying time and recoating interval depend on factors such as paint dry film thickness, ventilation, humidity and previous paint.

(2)The surface must be dry and free of dirt before recoating. Adhesion is best when the previous coating is completely dry before applying the subsequent coating. If the coating is exposed for a long time, the surface must be roughened before recoating to ensure adhesion between the coatings.

Surface treatment

The painted surface must be dry ; SSPC-SP1 According to the regulations , use solvent to remove all grease from the surface ; use clean water to remove salt and stains from the surface . The corroded area must be repaired with a suitable primer .

Construction conditions

The surface temperature of the substrate should be at least 3 °C higher than the air dew point temperature, and the relative humidity should not exceed 85% (the temperature and relative humidity should be measured near the substrate).

The surface temperature of the substrate should not exceed 40°C . Otherwise, a suitable spraying method should be selected and appropriate diluent should be added as required to prevent dry spraying. In extreme cases, the dry film thickness of the coating can be appropriately reduced to prevent sagging.

When painting in a confined space, proper ventilation should be provided to ensure the paint film cures. The paint temperature must be above 15 °C, otherwise thinner should be added to achieve the required viscosity for construction.

Recommended Package

The following are typical high-performance coating systems:

Store

Must be stored in accordance with national regulations. The storage environment should be dry, cool, well-ventilated, avoid high temperatures and stay away from fire. The packaging container must be kept sealed. The storage validity period is at least 12 months.